“Hi, Will the auto dialer work with an Accenta G4 panel? Thanks.” Yes our GSM Auto Alarm Dialer is compatible with your alarm panel. It requires only 3 connections to your panel PCB (+VE, 0V and Bell -) and may fit within your alarm enclosure. If there is no space then your can use the external enclosure available on our dialer page.
You can also connect the three wires to the communicator connection (centre left) using the 13V, 0V and COMMS terminals as above however this will require the engineer to active these terminals within your panel interface.
To set the system up for basic operation will then require just two messages to be sent to the SIM card number:
master <your number no spaces within the number>. e.g. master 07830111222.
callnumA <recipient number>. e.g. callnuma 07574222333
textnumA <recipient>. For anyone wanting a text message when the alarm sounds.
Input B can be connected to the SET terminal next to the BELL – terminal. This allows you to see if the alarm is SET and will notify you of this when it changes state. You may wish to setup CALLNUMA(s) for the alarm so it dials only when the alarm sound and have seperate TEXTNUMA and TEXTNUMB if you use the input B for this purpose. This panel is very similar to the one shown in the video:
http://www.youtube.com/watch?v=7F4T-54yb_8
The GSM Dialer is available from our website here GSM DIALER
Hi. I was wondering if you could supply a wiring diagram for a Castle Care Tech 1600 system?