Wiring guide GSM Alarm Auto-dialler with Texecom Veritas R8 with Alarm Reset

GSM SMS Sender to Veritas R8 Alarm

GSM Dialler Wiring Diagram

We have a simpler wiring diagram for basic connection available here.  The above diagram allows for controlling the alarm via your phone and monitoring it’s status.  To power the GSM Dialer you can use the auxiliary output on your Texecom panel.  The positive (+) terminal is connected to one of the VIN terminals (the lower one is best as it has on-board thermal fuse protection) and the negative (-) terminal to GND on the GSM Dialer PCB.  You then connect the BELL terminal to input A.

For switching the alarm on and off you wire the output relay to zone 8 using the NC&COM terminals (either way around).  To monitor the status of the alarm you connect the SW terminal to input B.

To program the dialer the following commands are sent:

master <your number>.   This gives you control of the dialler

callnuma <number 1 etc…>.   This sets the numbers to call when the alarm sounds

textnum <numbers>.    This sets the numbers to text when the alarm sounds or is set

Alternatively;

textnuma <numbers>.    This is just for when the alarm sounds (a)

textnumb <numbers>.   This would be just for when the alarm is set/unset (b)

To get a message when the alarms starts and stops send:

inlevela both

To get a message when the alarm is set and unset:

inlevelb both

 

To program the Veritas Panel zone 8 must be set as a key-switch input:

From the Programming Menu, press # followed by the
zone number (8). The Zone Type currently selected will
indicate i.e. Entry/Exit.

veritas-zones

Press the Zone Type number required – in this case 8 (keyswitch). Press PROG.
The system will chime to confirm the new Zone Type has
been accepted.

The defaults settings will be correct for the SW output.

 

 

The GSM Dialler is available from our online shop here

GSM Dialer

GSM Alarm Auto-dialer

Advertisements

One thought on “Wiring guide GSM Alarm Auto-dialler with Texecom Veritas R8 with Alarm Reset

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s